Print Page

Novaline® Fascia System

NOVALINE® is the fascia system that puts it all together, with an array of components designed to combine durability and good looks.

Novaline Fascia The NOVALINE® system lets you combine components designed to work together. It comprises fascia is COLORBOND® steel, metal fixing brackets, a good looking gutter profile in COLORBOND® steel, spring clips to fasten the gutter to the fascia and overstraps to suit the selected gutter profile.

NOVALINE® is compatible with D-Mould 115 Hi-front, Ogee and Squareline gutters.

INSTALLATION PROCEDURE

FASCIA INSTALLATION

Support Spacings

The NOVALINE® fascia should be supported on rafter clips at 1200 mm (maximum) centres for sheet roofing, and 600 mm (maximum) centres for tile roofing. Where steel roofing is used, the novaline fascia shall not be used as an end span support. If fixing to wood use Type 17 screws.

Diagram 1

Step 1 (Refer to note on support spacings) Attach rafter clip at each end of the run, then run a stringline from end to end of the run. Attach rafter brackets level and in line with the string line.

Diagram 2

Step 2 Hook the fascia horizontally under each end clip, then flip the fascia forward and lever over the top of the bracket into the vertical position.

Diagram 3

Step 3 Adjust the fascia to the correct position by sliding it along the brackets, then secure intermediate brackets by twisting into fascia first, and then connecting to the rafters.

Step 4 Fit the fascia accessories as required. (i.e. Corners, End closers, etc.)

Gutter Installation

Step 1 Straddle the Spring Clip over the fascia by rolling from behind and up over the fascia to the vertical position.

Diagram 5

Step 2 By hitting the top of the clip down with a closed fist, push the clip all the way down into place. Place two clips a maximum of 1200 mm apart over the fascia at the mid-point position of the length of the gutter about to be installed.

Diagram 6

Step 3 By holding the gutter from underneath, push the rear of the gutter up between the fascia and the clip. Push the gutter up so that the top zinger (rib) is placed between the 1st and 2nd barb of the Spring Clips.

Diagram 7

Step 4 When fastening the clips as you work your way down from the high end to the low end, push the clip down over both the fascia and the gutter together, then push the gutter back up to the desired level to retain a (minimum) fall of 1 in 500.

Diagram 8

Step 5 Locate the gutter overstrap beside each Spring Clip by engaging under the front of the gutter bead, then roll the rear of the overstrap back towards the fascia. Secure the overstrap by folding the tail behind the fascia.

Diagram 9 Diagram 10